CopyPastehas never been so tasty!

Metal Roof Installation: Steps to Abide by

by allysonduguay

  • 0
  • 0
  • 0

For your Tampa house, metal is one of the finest roofing products you may possibly utilize. With the wet subtropical climate of Tampa, metal is the perfect material to stand up to such weather conditions. Metal roofs are heavy duty, lightweight, and low-maintenance, among other benefits. Metal roofs are either the exposed fastener or the concealed fastener type. The following kinds pertain to the setting up of the former, which is the type most do-it-yourselfers choose, as a result of the convenience of installation and the price.

Prepare Your Panels

When you put in the first panel, ensure it's square so it's easier for the other panels to follow. Pre-drill the panels to make the screw lines straighter; pierce about 10 panels each time. Panels have an underlap and overlap leg; identify which is which before you start installation. Begin at the end of the structure, following the movement of the wind.

Prepare the Roof Deck

Wrap up the sheathing with a 30-pound building felt, and lay down 1 x 4 strips on top of this. Attach eave flashing, and overlap these with the gutter. Cover the eave flashing with inside-closure bands; cover these, then, with butyl tape sealant.

Affix the Panels

The first panel ought to dangle over the eave by about 3/4 inches. Make use of self-tapping gasket, cap, stopper head wood screws to keep the panels in position. Set up the subsequent panels with the same method, making certain that the underlap and overlap legs are arranged accordingly. Keep doing this until the entire roof is covered.

Put up the Rake or Gable Flashing

Affix rake or gable flashing to the sloped roof edges the way roofers Tampa locals rely on do. Use butyl tape sealant in the segment where the flashing and roof panels join. Push wood screws through the flashing, sealant, and roof panels to affix all of these to the underlying sheathing. The flashings should likewise overlap and bind each other using additional tape sealant.

Set up the Peak Flashing

To additionally safeguard the metal roofing Tampa residences have, peak flashing must be laid on top of all the components discussed above. Foam outside-closure bands are attached to the panels using butyl tape sealant. These bands are covered with more sealant, and the peak flashing, then, is placed over the sealant. The flashing is additionally held in place using metal stitch screws.

After you're done with the job, eliminate metal shavings on the roof covering, lest they cause your roof covering to rust if left there too long. If you deem this too troublesome to carry out on your own, choose roofing contractors Tampa homeowners rely on. For additional ideas on metal roof installation, visit

Add A Comment: