CopyPastehas never been so tasty!

Measuring The Double Glazing Glass Unit

by kevinalexx

  • 0
  • 0
  • 0

After eliminating the Double Glazing Unit you should take it to your local Glass Vendor for them evaluate it and check for any unique coverings that the cup may have on it. If the Skylight Glazing Unit was seated on nasty packers when you eliminated it, take them with you and ask the Glass Vendor if they are the appropriate packers for the job, if not, get the appropriate packers. This is very important as the cause of most Stick Glazing Unit Failures (misty / moisture build-up or condensation between glass) is that they have not been fixed on the appropriate packers. If your screen is hard on protection record you will need to buy some new dual on the side protection tape.


Re-Fitting an Internally Glazed Double Glazing Unit:

Make sure it is rectangle in the structure and you have it seated on your two packers. Fit the two quickest pellets first by hitting the in with a nasty hammer. Then fit the two lengthiest pellets in the same way. You may need to force one end of the pill into place and fold the pill to get the other end in.


Re-Fitting an Externally Glazed Stick Glazing Unit:

Back gasket program - Fit the cup and pellets as described above and then force the rubberized gasket returning into the structure on the within of the screen. If the rubbers have reduced you can carefully expand then out and re-fit them with a small blob of superglue in each area to stop them from reducing returning again.


Security tape program - Fit the new record to your screen structure, getting good proper want to keep it cleanse with the structure advantage. Eliminate the protecting and apply the record with screen better. This will allow you to move and arrange the Structural Glazing Unit. The screen better will disappear in several hours making you with a Unitized Structural Glazing Unit that can only be eliminated by reducing it out from the within. Fit the cup and pellets as described above.


One term of caution: Some Externally hard supports have Glass Hair fixed to them. Glass Hair are right place items of steel that are placed into unique owner segments connected to the structure. If you take away the pellets and see these steel segments, contact a glazier as these segments can be very challenging to eliminate without the appropriate resources.


If you are not sure which program you have or are not assured enough to continue with the job, contact a glazier. It will be less expensive in the long run to get someone who knows what they are doing than ruining your windows.


For more information about spider glazing, structural glazing, semi unitized structural glazing, unitized structural glazing, double glazing, skylight glazing & stick glazing visit GK Alu Fab. Take a look by clicking the Links.

Add A Comment: