CopyPastehas never been so tasty!

More On New Orleans Brake Repair

by anonymous

  • 0
  • 0
  • 0

Hydraulic operation of service brakes has been the universal design for more than 60 years. The complete hydraulic brake system consists of the steel lines, master cylinder,  rubber hoses, brake apply devices at each wheel and pressure-control valves. The master cylinder is the start of the brake hydraulic system.  If some goes wrong with the brake system then make sure to get it done from the New Orleans brake repair professional. It actually is a cylindrical pump. The cylinder is scaled at one end, and the movable pushrod extends from the other end. The pushrod moves a pair of in-line pistons that produce the pumping action. When the brake pedal lever moves the pushrod, it moves the pistons to draw fluid from a reservoir on top of the master cylinder. Piston action then forces the fluid under pressure through outlet ports to the brake lines.


All master cylinders for vehicles built since 1967 have two pistons and pumping chambers .Motor vehicle safety standards require this dual-brake system to provide hydraulic system operation in case one hose, line, or wheel brake assembly loses fluid. Because the brake hydraulic system is sealed, all the lines and cylinders are full of fluid at all times. When the master cylinder develops system pressure, the amount of fluid moved is only a few ounces. Modern-day vehicles have split brake systems. The pre-1970s vehicle had a single hydraulic system serving all four wheels. A leak anywhere in the system resulted in a complete braking failure. The split system was designed to prevent a total system failure. This required the use of a dual-piston master cylinder and the inclusion of various valves. A split system is fed by one piston in the master cylinder and feeds two wheel brakes of the vehicle. There are two types of split systems: diagonal and front/rear. The diagonal has one system feeding a front-wheel brake and the rear, opposing-side wheel brake, that is, left front and right rear. The second diagonal split is to the other wheel brakes. The front/rear split is exactly as it sounds. One side or split feeds the rear-wheel brakes and the other feeds the front wheels . Both types of split have advantages and disadvantages, but each prevents complete system failure from a single leak.


The rigid lines or pipes of a brake hydraulic system arc made of steel tubing for system safety. Flexible rubber hoses connect the wheel brakes to the rigid lines on the vehicle body or frame. The front brakes have a rubber hose at each wheel to allow for steering movement. Rear brakes may have separate hoses at each wheel or a single hose connected to a line on the body or frame if the vehicle has a rigid rear axle. Brake lines and hoses contain the high-pressure fluid, and the fluid acts as a solid rod to transmit force to the wheel cylinders and caliper pistons. A New Orleans brake repairprofessional could repair and maintain it properly and effectively.


Author resource:


The Author is conveying information about Car repair New Orleans and New Orleans brake repair. You're probably thinking, everyone says that, so, what's different here. It's the commitment of quality, genuineness, and a guarantee that values your time and interest.

Add A Comment: